Orange Circle 28/410 28/415 Plastic Trigger Sprayer Used For Cleaning Bottles

Step 1: Attach the Sprayer to the Bottle

1. Check Compatibility – Ensure the bottle has a 28mm neck (standard for 28/410 sprayers).

2. Remove any seal – Peel off the foil or plastic seal from the bottle opening.

3. Screw on the sprayer – Twist the trigger sprayer clockwise until snug (do not overtighten).

Step 2: Prime the Sprayer (If Needed)

• Some sprayers require priming (pumping the trigger a few times) before the first use to draw liquid into the nozzle.

• If nothing comes out after several pumps, check for clogs or improper sealing.

Step 3: Adjust the Spray Pattern (If Applicable)

• Rotate the nozzle to select:

  • Mist (for wide, gentle coverage – e.g., glass cleaners).

  • Stream (for targeted, concentrated spraying – e.g., stain removers).

  • Jet (for high-pressure cleaning – e.g., outdoor sprays).

Step 4: Spray the Liquid

1. Hold upright – Tilted bottles may not dispense properly.

2. Press the trigger – Use steady, even pressure for consistent spraying.

3. Release to stop – The sprayer will automatically reset.

Step 5: Lock the Sprayer (If Equipped)

• Some models have a locking mechanism (twist or push-lock) to prevent accidental spraying during storage.

Step 6: Refill & Reuse

• Unscrew the sprayer and refill the bottle as needed.

• Rinse the sprayer if switching chemicals to avoid clogging.

Troubleshooting Common Issues

❌ No spray? → Check for clogs, ensure proper sealing, and prime the pump.